Remote settings

You’ll find here the remote settings you can apply to Usine objects. Midi and key learn, bindings and movement records

clear learn

Clicks this button to reset the last learn for this object.

general learn

mode

There are three MIDI assignation modes in Usine:

  • Absolute the controller sends a MIDI message with a value between 0 and 127 (typically rotary knob, fader).

If you create a midilearn NOTE ON on a switch, the value is set to 1 while the key is pressed and set to 0 when released. If you create a keylearn on a switch, the value is set to 1 while the key is pressed and set to 0 when released.

  • Relative the controller sends a MIDI message with a positive value when you turn right and negative when left (typically endless knobs)
  • Toggle the control toggles its minimum / maximum value each time it receives the learned code. Typically, if you want to assign a MIDI NOTE ON message, to an on/off parameter, for example, start playing a wave file while playing a MIDI keyboard note, you can toggle it on or off, when the same note is played again.

On List box or integer faders, the Toggle mode increases the current value until the maximum is reached. Then restarts from the minimum value.

inverse

Inverse the values for this learn.

quantize

Quantization value for the MIDI/Key learn.

  • no quantization
  • cycle
  • Bar
  • beat
  • 1/8
  • 1/16

key learn

Click on this button and use a key of your keyboard to assign it.

key

Key used for learn.

MIDI learn

MIDI learn settings for this object.

channel

MIDI channel used.

control type

MIDI message type used:

  • None
  • NOTE OFF
  • NOTE ON
  • POLY AFTERTOUCH
  • CONTROL CHANGE
  • PROGRAM CHANGE
  • CHANNEL AFTER TOUCH
  • PITCH BEND

control num

Controller number used.

motorized

Only if you have motorized MIDI controllers connected. Force Usine to send MIDI messages to the connected remote devices.

mackie mode

Integration of Mackie control protocol.

soft take over

Soft Take Over if a control is moved on screen and it no longer matches the hardware control, the control will not update until the hardware control matches the onscreen value. For instance say you have a line fader turned all the way up on the hardware, then you move the onscreen line fader to the bottom. With soft-takeover ON, the onscreen fader will not react to the line fader until you move the line fader all the way down to match the on screen value. The control will then latch on and will be active again.

record

record quantize

Add quantization to the recording

  • free(no quantization)
  • cycle
  • bar
  • beat

speed

Multiplication factor added to the recording speed.

clear record

Clear the current recording.

bindings

binding

Set or get the bind name.

clear binds

Clear the current bind assignation.

Mappings

range min

Minimum range of the bind assignation

range max

Maximum range of the bind assignation

curve

Curve type used :

  • log or exp
  • power curve
  • linear

coeff

curve coefficient. see above.